Read Carefully Before Use

Jun 3, 2026 www.hydrogeninhalationmachine.cn
Thank you choose our hydrogen inhalation machine.
Prohibit:
Do not use in confined spaces!
Flammable gas, no ignition test!
Do not block the gas outlet when the machine is running!
Please unplug the plugs of H and O outlets before turning on the machine.
Warn:
Keep away from fire when the machine is running!
When leaving the machine, please pause or turn off the machine!
Maintain:
Please add TDS=0 distilled water.
Add water to the new machine and soak for 20 minutes(Since the hydrogen-oxygen generator is drained of water prior to shipment, the internal proton membrane remains in a dry state during transit. Therefore, upon receiving the unit, you must first press the "Add Water" button to fill the reservoir. Do not attempt to use the device immediately; instead, allow it to soak 20 miniutes so that the proton membrane can fully absorb the moisture before powering it on.), After soaking, you can directly press the Start button; there is no need to discard the soaking water.
How To Use(take 3000ml as a example):
 
1.Turn on the power, connect the water pipe.
Press the gray clamp with one finger and remove the plug with the other hand( remeber one finger must press the gray clamp),After removing the plug, insert the water supply pipe firmly into the tank and put the other end into purified water or distilled water (TDS=0).
3.Press the water adding button on the screen, it will add water automatically.
2.Timing function:press the plus and minus signs . You can set it for 1-8 hours.
3.The Flow Rrate Range(take 3000ml as a sample): press the plus and minus signs on the right to adjust the flow rate from 1500ml to 3000ml. There are 16 gears to adjust.
4. One person inhales the H2&O2 Connection
First connect the Y tube then  connect the cannular like following, then you can inhale the H2&O2 now.
5.Two people inhale together
Use" Y "connector and "T" connector to connect the nasal cannular on both sides like following,then two people can inhale hydrogen at the same time
6.Make hydrogen water (optional)
Use a tube, one end connect to H2 outlet, the other end connect into Hydrogen dissolved rod, leave the O2 output open, put rod into water, after 5-7 minutes later, can drink the hydrogen water.
7. Use hydrogen eye goggle and earplug.
Use Y tube connect the H and O outlet, then connect the T tube, cannlulars connect one outlet of the T tube, goggle and earplug connect into T tube another outlet, then you can enjoy the eye and ear spa while you are inhaling the gas.
8. Drain Water Connect the drain pipe.
Unplug the add water pipe and plug it with the original plug (when pulling it out, remember to press the gray retaining spring with one finger while pulling it out).
Use the same method to remove the drain pipe plug and install the drain pipe,the drain pipe the other end put it in a container ,then press the "drain water" botton on the screen, It will drain water automatically.(Please note that the drained water cannot be reused).
 
Back to the blog title

Post comment

Please note, comments need to be approved before they are published.